The right control is only as good as what supports it. Our accessories are built to work directly with Control Resources products, giving your system what it needs to perform exactly as designed.
A handheld programming tool that lets you configure and fine-tune Control Resources controls on-site, without pulling the board or writing a line of code.
A handheld LED stroboscope for measuring and verifying RPM, built to handle 60 to 99,990 flashes per minute, without touching the equipment under test. Point it at a rotating component, dial in the frequency, and read the speed directly.
Precision air and surface temperature sensors compatible with all Control Resources products except the Nimbus, and Omni SD. Built for tight spaces and demanding environments.
A compact, lightweight air temperature sensor built for confined spaces where every millimeter counts. When your enclosure doesn’t have room to spare, the S1 fits without compromise.
A PCB-mount mini air temperature sensor designed for direct board integration. It sits flush, stays stable, and keeps your assembly clean.
A surface temperature sensor with lug-mount hardware for reliable contact on motors, housings, or heat sinks. Built for accurate surface reads in production environments.
An air temperature sensor with a TPE-moulded body for added flexibility and durability. The molded construction holds up in applications where vibration or mechanical stress is part of daily life.
A full-range lineup of air and surface temperature sensors compatible with all Control Resources products. Whether you’re monitoring ambient conditions or liquid temperatures, there’s a P Series sensor built for it.
An air temperature sensor with a mounting clip for quick, secure installation. Point it where you need it, clip it in place, and you’re done.
The same reliable air temperature sensing as the P1-F, minus the clip. A low-profile option when mounting hardware isn’t part of the picture.
A liquid temperature immersion sensor for applications where you’re monitoring fluid, coolant, or process liquid temps.
A surface temperature sensor with a lug mount, purpose-built for direct contact with motors, pipes, and housings.
An air temperature sensor built for straightforward ambient monitoring. Dependable, compact, and compatible across the full Control Resources product line.
Everything you need to install Control Resources products securely, including connectors, terminals and mounting.
DIN rail mounting kit for the Cirrus 2 and Cirrus ECM.
Control Resources
Better Data
Your control is only as smart as the inputs it receives. The right sensor gives it accurate, real-time data to act on, so your system responds the way it was designed to.
Easier Setup
The Navigator cuts down configuration time on-site. No special equipment, no guesswork.
Built to Fit
Every accessory is engineered specifically for Control Resources products, which means no compatibility workarounds and no signal translation headaches.
From first prototype to full production runs, our design-to-build process keeps everything under one roof. You get a control engineered around your exact specs, built and tested in Massachusetts, with the same team supporting you through the life of your program. If your application runs on a fractional HP motor, let’s talk.
Engineering insights, product updates, and resources to help with your next project.
If your current control is holding your product back, or you’re starting from scratch and need a partner who’ll see it through, let’s dig into the details together. Reach out to the team and we’ll take it from there.
It depends on your product. S Series sensors work with most Control Resources controls, with the exception of Nimbus, and Omni SD. They also provide better accuracy at a lower cost.
P Series sensors are compatible across the full product line. If you’re not sure which applies to your setup, reach out and we’ll point you in the right direction.
Yes. Our temperature sensors are designed to integrate with both catalog and custom Control Resources controls. During the design process, we factor in your sensing requirements so the control and sensor work together from the start.
The Navigator is designed for use with Control Resources controls that support on-site programming. If you’re unsure whether your specific product is compatible, contact us and we can confirm before you order.
You need the hardware pack for each board to connect to the sensor, so it depends. Our sensors and the Navigator are built to connect directly to compatible Control Resources products. Standard installation instructions are included, and our team is available if you run into anything unexpected.
