SmartFan®Aurora
INSTALLATION
SmartFan Aurora DC Motor Speed ControlOperation/Installation Manual
Mounting: Mount the Aurora on a flat surface using all four mounting holes for maximum support. The board may be mounted using metal
screws or Nylon supports such as Richco No. CBS-4-19. Alternatively the Aurora can be mounted on a DIN rail using DIN rail kit, CRI P/N
DIN600-F.
CONNECTIONS
Input Power Connection
Refer to Figure 1 for input power wiring. Aurora can supply up to 6.0 Amps at 55 C maximum operating temperature to the motor load.
Motor Output Connection to Header TB5
Fans or motors are connected to header TB5. Refer to Figure 1 for details of wiring. More than one fan can be connected in parallel to header TB5 as long as the total current draw of the fan load does not exceed the 6 Amp rating of the Aurora.
Isolated Voltage Control Signal Connections
The Aurora will accept a signal producing an output of 0-5 VDC or 0-10 VDC. Connection is made at Terminal Block TB2. Refer to Figure 1, Aurora Connections Diagram.
Isolated Current Control Signal Connection
The Aurora will accept a signal producing an output of 0-20 mADC. Connection is made at Terminal Block TB2. Refer to Figure 1, Aurora Connections Diagram.
Isolated Potentiometer Signal Connection
The Aurora will accept a signal from a 1KO to 10KO potentiometer. Connection is made at Terminal Block TB2. Refer to Figure 1, Aurora Connections Diagram.
ADDITIONAL MANUAL PAGESOperation/Installation Manual
Use the links below for addtional manual pages or for a complete manual or click on the Operation/Installation Manual PDF link above.
